Straw Polyhedron
Materials and tools
Introduction This explanation sheet shows how to make three dimensional-shapes with plastic straws without any glue. Each edge is connected by two apex joints. The joints are also made with plastic straws. We need different numbers of straws in order to make different polyhedron. For example, to make tetrahedron a joint needs 3 pieces of short straw and to make octahedron we use four pieces. The following table shows required numbers of short straw.
Table 1.
* v + f - e = 2 Sample: How to make a 4 arm joint for octahedron Follow the drawing and explanation below to make good joints. When you insert the short arm into next straw’s long arm, it is very easy to slide the short arm up to the end of the slit on it, but from the end of the slit it becomes difficult then squeeze short arm slowly and firmly into the long arm. After you cut out a small straw, make a transverse slits apart about 2.5cm from one edge of the straw. Do not cut the straw thoroughly. Cut about 70% of straw’s diameter. Then make a longitudinal slit on both arms of the straw. The depth of longitudinal slit on joints’ arms depends on the hardness of the straw. Adjust the depth flexibly to the quality of your straw.
In order to make a regular octahedron, prepare 12 same length long straws, then push each joint arm into long straw and connect 8 triangles. It becomes a regular octahedron. Pictures below show alternative method for how to connect four short straws.
How to make a 3 arm joint When you make a tetrahedron, a hexahedron (cube) and a dodecahedron model, use 3 arm joints shown below. Pictures below show how to connect four short straws.
Other samples of Math model
You can apply this technique to make various different mathematical shapes and models. Check the following pictures. Three dimensional-shapes composed of triangular shape are strong enough to keep the shape while squares and pentagons are not strong enough. In order to make a strong straw model, add some triangular structure in the model like reinforced cube model below.
“Straw polyhedron” copyright JICA Senior
Volunteer Hideo Nakano (Dec 2005, revised September 2007) |
SEO | [PR] 爆速!無料ブログ 無料ホームページ開設 無料ライブ放送 | ||